Member Reviews for Baron Custom Accessories Baron's Bullet Tachometer, 1 inch Bar, Black Face- For Most 2 or 4 Cylinder Motorcycles

CruiserCustomizing Staff Pick Important: SEE FITMENT DETAILS!

Write a review and share your experience with other members.

Average Customer Review: 4.49 (based on 287 reviews)

Breakdown:
3 Reviews
1 Review
1 Review

Sort By: Newest Oldest Highest Rated Lowest Rated Helpful Reviews

(2 stars) reviewed on 08/04/05 by barrski (barryinn) from Denham Springs, LA, United States, for a 2003 Black Pearl 1500 Vulcan Nomad Fi wrote: Finished!!!!!!!! What a job!!!!! This tach took me 6 hrs. to install...on a vulcan nomad. I had to remove the tank and add extra wire to the tach,you might not have to do this but I chose to. I downloaded diagrams from Kawasaki to know where the coils are located. That was my most concern since I am not a mechanic. There was more wiring I had to move ouy of the way, but once I new what to do it worked fine. The Tach works great! , jumps around a bit at idle, smooths out at higher rpm's. Be sure you have everything you need before starting, it helps if you want to getter done. Update 7-3-07 Left my motorcycle out in the rain for the first time since installing this Tach, BAD IDEA! , now it has moisture in it and it is now fogging up on the inside. I thought these were water proof? Review Details  8 out of 8 members found this review helpful. Was this review helpful to you? Yes No

(5 stars) reviewed on 07/20/05 by Sunny (SunnyBob) from , , Americas, for a 2000 1500 Vulcan Nomad Fi wrote: wonderful looks, works very well, just a bit on the dear side. Review Details  1 out of 2 members found this review helpful. Was this review helpful to you? Yes No

(5 stars) reviewed on 06/25/05 by Scott (sfitzsim) from Albert Lea, MN, United States, for a 2004 1500 Vulcan Nomad Fi wrote: Easy install, especially if you take your tank off. If you are installing on stock hendlebars with stock risers, you will need to tighten the back screw first with the tach tilted back as far as possible, then the front because there is not enough room to get the allen key in to tighten the bolt. Fits well, looks great! Review Details  5 out of 6 members found this review helpful. Was this review helpful to you? Yes No

(5 stars) reviewed on 05/21/05 by Sharky (shark2004) from Mechanicsville, VA, United States, for a 2004 1500 Vulcan Nomad Fi wrote: Took 2 hrs - had to remove the tank - Empty the gas before you start - Review Details  1 out of 3 members found this review helpful. Was this review helpful to you? Yes No

(4 stars) reviewed on 12/31/04 by Lavan "BUM" Thompson (lavan) from Brazoria, TX, United States, for a 2002 1500 Vulcan Nomad Fi wrote: another xmas gift havent installed yet Review Details  0 out of 3 members found this review helpful. Was this review helpful to you? Yes No