Member Reviews for Cobra Freeway Bars - 95-99 Shadow ACE 1100

Important: SEE FITMENT DETAILS!


View installation guide

All Cobra products are made in the USA

Write a review and share your experience with other members.

Average Customer Review: 4.38 (based on 86 reviews)

Breakdown:
47 Reviews
27 Reviews
10 Reviews
2 Reviews

Sort By: Newest Oldest Highest Rated Lowest Rated Helpful Reviews

(5 stars) reviewed on 07/09/11 by (buzzweiser34) from , MI, United States, for a 2003 1100 Shadow ACE wrote: Fairly easy to install. Removed tank for easier access to bolts at top. LOOK GREAT! Review Details  Was this review helpful to you? Yes No

(5 stars) reviewed on 11/29/10 by Paulo Mosquera (pmosquer) from MEDELLIN (COLOMBIA) SOUTH AMERICA, AK, Americas, for a 1996, Black 1100 Shadow ACE wrote: Amazing look. Review Details  Was this review helpful to you? Yes No

(3 stars) reviewed on 02/28/10 by Clayton Roush (bighonda) from Brighton, CO, United States, for a 1997 Black and Yellow 1100 Shadow ACE wrote: Very solid product Review Details  Was this review helpful to you? Yes No

(5 stars) reviewed on 11/02/09 by (retiredgunny) from Washington, NC, United States, for a 1997 Cream/Silver 1100 Shadow ACE wrote: I installed it myself, after contacting Cobra. It was not an easy fit. Then I had to take it to the dealer to adjust and put in the correct spacer. But, it is a very good item to have on your bike, I would not be without it. Review Details  Was this review helpful to you? Yes No

(4 stars) reviewed on 10/22/09 by Erwin van Waes (erwinvanwaes) from Clinge, Netherlands, , Europe, for a 1996 1100 Shadow ACE wrote: Came with the bike when I bought it Review Details  Was this review helpful to you? Yes No

(4 stars) reviewed on 08/11/09 by yankees (yankees) from nieuwegein, holland, , for a 1995, the bike you see is my vt1100c from 88 1100 Shadow ACE wrote: very nice part Review Details  Was this review helpful to you? Yes No

(5 stars) reviewed on 04/09/09 by chad sommers (ghartford420) from , WI, United States, for a 0 1100 Shadow ACE wrote: Looks good , easy install , would be better if I had floor boards Review Details  Was this review helpful to you? Yes No

(5 stars) reviewed on 04/01/09 by Dan (danlnc) from Locust, NC, United States, for a 2001 1100 Shadow ACE wrote: great look Review Details  Was this review helpful to you? Yes No

(5 stars) reviewed on 03/02/09 by Troy Gibson (ebony1jack) from pinckney, MI, for a 1995 1100 Shadow ACE wrote: fit ok look good once i added foot pegs i ride using them primarly Review Details  Was this review helpful to you? Yes No

(5 stars) reviewed on 02/20/09 by david vaughan (chefdavid) from greenbrier, TN, United States, for a 1997 1100 Shadow ACE wrote: Real nice !! Great look and Great protection. Review Details  Was this review helpful to you? Yes No

(4 stars) reviewed on 12/12/08 by Tim Forman (tforman) from Powder Springs, GA, United States, for a 1997 1100 Shadow ACE wrote: Great product. Installed with ease! Review Details  Was this review helpful to you? Yes No

(5 stars) reviewed on 10/30/08 by Ricardo H. Garduno (garduno69) from Mexico, , Americas, for a VT1100C2 ACE 1996 1100 Shadow ACE wrote: Excellent product and very easy to use Review Details  0 out of 1 members found this review helpful. Was this review helpful to you? Yes No

(4 stars) reviewed on 07/09/08 by (Livshadow) from Ocala, FL, United States, for a Silver and White 1997 1100 Shadow ACE wrote: 7/09/08 Installation was not hard. It took me about 30 minutes from start to finish by myself. I started with the lower left side of the bar and continued with the lower right then the upper left and finished with the upper right. I did not need the supplied spacer because I used the washers that were there at the start of the project. I did not tighten any bolts and nuts until everything was in placed and lined up. I read a lot about the problems others had installing the bars and found it easier to just purchase Chrome Acorn Nuts and used the bolts and lock washers that came with the freeway bar. I used a ½ inch socket to stop the top bolts from turning as I tightened the acorn nuts. Be sure to pull the bar forward when tightening it down to avoid vibration rubs with the radiator hose and tubing on the bottom. Installation may be a different story if you have to contend with a floorboard. I have pegs. The Chrome acorn nuts really help set off an already good looking product. The... Review Details  7 out of 7 members found this review helpful. Was this review helpful to you? Yes No

(4 stars) reviewed on 05/18/08 by Ron (Ronbo99) from Florence, KY, United States, for a 1996 1100 Shadow ACE wrote: Very satisfied with this accessory. Makes the bike look and feel bigger. Had to tug and pull a little bit to install but overall not too bad. Review Details  Was this review helpful to you? Yes No

(4 stars) reviewed on 03/16/08 by fitz (fitzyagood) from Rockford, MN, United States, for a 1998 1100 Shadow ACE wrote: pretty easy to install. looks great Review Details  Was this review helpful to you? Yes No

(4 stars) reviewed on 09/22/07 by (tigerman927) from fernley, NV, United States, for a 1996 1100 Shadow ACE wrote: was on bike when purchased Review Details  Was this review helpful to you? Yes No

(4 stars) reviewed on 08/04/07 by sheriff hughes (lhughes) from west jordan, UT, for a 2005 1100 Shadow ACE wrote: This was a good addition. The price was great. It took about 1 hour to install and required a little patience. The only complaint I have is why wouldn't Cobra send Chrome bolts with Chrome bars. Review Details  Was this review helpful to you? Yes No

(4 stars) reviewed on 07/31/07 by Flipper (flipper703) from Jefferson, WI, United States, for a 1995 purple and white 1100 Shadow ACE wrote: I love the looks of these!! And for the price I could not pass them up. Review Details  Was this review helpful to you? Yes No

(4 stars) reviewed on 07/09/07 by Scott Foster (CosmicCowboy) from Murfreesboro, TN, United States, for a 1997 1100 Shadow ACE wrote: Still haven't found a way to keep this off the exhaust, but no complaints aside from that. Watch the lower radiator tube. You can bring the bars forward a little to keep it from rubbing. Review Details  1 out of 1 members found this review helpful. Was this review helpful to you? Yes No

(4 stars) reviewed on 03/26/07 by Scott Powell (scty_p) from Cobourg, , United States, for a 1997 1100 Shadow ACE wrote: Installation was fairly straight forward. The welds at the flanges could've been a bit neater especially at the top attachment point to the frame gusset; the heads of supplied bolts hit on the welds before bottoming out on the flange. I went out and picked up some stainless socket head cap screws (allen key bolts) and that did the trick. Cobra's chrome has to be one of the best! Review Details  2 out of 2 members found this review helpful. Was this review helpful to you? Yes No