|
|
|
Hondaline Chrome Front Fender Ornament - VTX 1300R/T
| |
|
| |
|
Buy Now from CruiserCustomizing
|
Part Number:
HL-08F85-MEA-100
|
|
|
This buffed and polished chrome accent piece compliments your bike's front fender. Unique styling integrates the VTX emblem into the design of the ornament.
This accessory fits all current model years for:
- Honda VTX 1300 Retro
- Honda VTX 1300 Tourer
Member Controls
Email to Friend
Add to "My Accessories"
Add to Wishlist
Get Price Alerts
Member Reviews
Write a review and share your experience with other members.
Average Member Review:
4.72 (based on 127 reviews)
Would buy again:
100%
Here are the 3 most recent member reviews for this accessory.
See all Member reviews...
(4 stars) reviewed on 06/08/09 by
Eric
(theswoopman)
from Buckhannon, WV for a 2004 VTX 1300 Retro wrote:
Nice addition, Easy Install.
Review Details
Was this review helpful to you?
Yes
No
(5 stars) reviewed on 03/20/09 by
ziad
(zsnajjar)
from indianapolis, IN for a 2002 VTX 1800 Retro wrote:
Looks great
Review Details
1 out of 1 members found this review helpful.
Was this review helpful to you?
Yes
No
(5 stars) reviewed on 01/24/09 by
Scotty Gibbs
(colonelg1990)
from San Antonio, TX for a 2006 Candy Black Cherry VTX 1300 Retro wrote:
This piece is a must have for the traditional retro look! I used this along with the MC Enterprises Two Rail Front Fender Trim and the Hondaline Chrome Front Fender Rear Tip. The three pieces really dress-up the front fender. Installation tips: I would cover the fender from side-to-side in the area of the forks with painter's tape (blue tape in the paint section of Lowe's or Home Depot), as you will have to remove all 4 bolts holding the fender in place to raise the fender high enough between the forks to install and tighten the bolt from the under side of the fender. I used shop rags/t-shirts to place between the fender and the tire to hold it up while I was drilling and performing the installation. This technique will allow you to eaisly perform the installation by yourself. I used blue loctite on the bolt and put silocone inside the ornament to assist the sticky tape with adhesion. Lastly, I used a 1/4 inch drill bit instead of the 6.5 mm and it worked perfectly.
Review Details
1 out of 1 members found this review helpful.
Was this review helpful to you?
Yes
No
See all Member reviews for Hondaline Chrome Front Fender Ornament - VTX 1300R/T
|