Kisan TailBlazer - Splice In Unit

100HD-M unit is designed to handle up to (4) tail light bulbs

100HD-M has a built-in ballast to allow continuity during the flash mode. It has a high-side interrupt circuit to allow flashing of the bright brake filaments. This makes it easy with just a single wire splice.

100HD-M unit mounts in the tail section or under the seat.

When you apply the brakes the brake light will modulate rapidly at first then slow down to a solid ON over a period of (4) seconds.

WHAT DO THEY SEE?

As soon as you tap your brakes, drivers behind you will see a rapid flash of the brake lights. This sudden flashing invokes immediate attention.

WHAT WILL THEY THINK?

tailBlazer uses a flash pattern which decays exponentially - a well-recognized deceleration warning. The attention to the initial flashing now changes to a clear recognition that you're beginning to slow down!

Simply flashing brake lights or flashing them on & off will get the attention of drivers behind you, but it doesn't invoke anything else. Every split second of delay in their reaction reduces your safety margin.

There is no sacrifice to the life of your bulb because tailBlazer utilizes a soft-switching technology. It throttles the current flow through the bulb filament, so that there's no "thermal shock" due to a sudden inrush of current, which can damage the bulb filament or shorten its life considerably. This is far superior than maintaining a small voltage!

The internal circuitry is controlled by a microprocessor, which allows precise flash patterns, overload detection and reverse polarity protection.