Member Reviews for National Cycle Street Shield EX For 1 In. Handlebars (Light Tint) - Various Motorcycle Models

Reviews:

3.0 of 5.0 Stars See All (68) Member Reviews for NC-N2568

National Cycle Street Shield EX For 1 In. Handlebars (Light Tint) - Various Motorcycle Models

ZOOM

Buy Now. Earn 144 Reward Miles!

Why buy from CruiserCustomizing?
- Satisfaction Guaranteed
- No Hassle Returns
- Expert Customer Service Team
- Thousands of Happy Customers

Part Number: NC-N2568

Important: SEE FITMENT DETAILS!

View installation guide

Member Reviews

Write a review and share your experience with other members.

Average Customer Review:

3.00 (based on 68 reviews)

Breakdown:

2 Reviews

1 Review

next Showing 1 - 3 of 3 next

(4 stars) reviewed on 08/07/07 by
Mr. Cojones (MrCojones) from Mt. Vernon, IN, United States, for a 2000 white/blue nostalgic paint Sportster wrote:

Good looking shield, Had to use some Yankee engineering to make the handlebar brackets to fit otherwise installation wasn't too much trouble. Will update after a good ride.
Review Details

2 out of 2 members found this review helpful.

Was this review helpful to you? Yes No

(4 stars) reviewed on 05/23/07 by
George Morley from Pontefract, , Americas, for a 2007 1200C black Sportster wrote:

Good value
Review Details

2 out of 2 members found this review helpful.

Was this review helpful to you? Yes No

(2 stars) reviewed on 04/11/06 by
Niteangel117 from Chillicothe, OH, United States, for a 2006 Sportster wrote:

I am the husband of the lady that wanted this shield and also the LUCKY soul stuck with installing it. This shield went on a 06 Sportster 1200C, I checked and it is listed to fit this bike. Harley must have changed something or I didn't understand the directions because this install was a bitch. I have been a mechanic for 10 plus years and I couldn't get this thing to fit right on this bike even after trying several different positions. The instructions said to place the supplied tape on the bars before placing the clamps in place. If you are going to install this shield you do need to do this because the clamps are molded just a little bigger than the bar in order to leave room for the tape. If you don't use the tape and try to tighten the clamp fully around the bar to make it seat then the clamp snaps. So use the tape. The lower mounts are held in place on the forks with hose clamps, I thought this was really kinda of cheap. Also the lower clamps use a “snap fit” rubber boot mounted ...
Review Details

18 out of 18 members found this review helpful.

Was this review helpful to you? Yes No

next Showing 1 - 3 of 3 next