Shop By Category
Shop By Brand
- Package Deals
- Holiday Zone
Serving Bikers Since 2001. More than 1 Million Packages Shipped!
Reviewed by: norsky (norsky)
Reviewed for: 1500 Vulcan Classic
Used for: < 1 month
Overall Rating: 5
Ease of install: 5
Would buy again: yes
This looks great on the bike and is a very simple install ....3 minutes should do it. Gather up your 3/4 inch open ended wrench and some silicon spray and you are ready to start. Realize this is two pieces and that the inner section may be tightly screwed in when you receive it. Remove the brass inner section and pull out the choke fully. Place the brass piece over the choke cable and inside behind the stock choke knob. Spray some silicon on the threads of both pieces and then put the new choke cover over the existing one. Then screw the new cover over the brass piece and tighten as much as you can. Next use the 3/4 wrench to tighten the brass fitting as much as possible......so it is very tight and you're done. Simple and a nice addition!
4 out of 4 members found this review helpful.
Was this review helpful to you?