Product Review

For Accessory:

Cobra 4-1/2 in. Spotlight Visor (for bullet shaped spotlights) - Sold Each

Reviewed by: Ken Angell (kendaman)
Reviewed for: 2004 Metallic Silver/Black 750 Shadow Aero
Used for: < 1 month

Ratings:
Overall Rating: 3

Ease of install: 1
Value: 4
Would buy again: yes

Review Summary:
I bought and installed these when I purchased the new Cobra light bar. Adds a nice retro look to an already good looking accessory and I love the way it makes the front of my bike look. Installation was extremely painful. To install the visors you have to remove the headlight housing cover and unplug the headlamp. Inside the cover are three metal clips that hold the headlamp in place. First you have to remove one of the clips by using a pair of needle nose pliers to push one side of the clip down and pull it out of the groove it sits in. You then have to remove 1 of the other 2 clips to be able to move the headlamp enough to slip the visor under the lip of the headlight housing. Next you need to make sure the headlamp is aligned in the housing properly and that the visor is centered at the top. Once you have these in place you need to firmly push the headlamp back into the housing and put the two clips back in place. This is harder than it was to get out (which was a pain) since there is even less room with the visor in place. It took several tries and a lot of frustration to get this to work. The part does not come with any installation instructions so you have to figure this all out on your own. After installing the first visor, the second took about half the time.

Review Pros:

Review Cons:

Review Improvements:

Review Tools:

4 out of 4 members found this review helpful.

Was this review helpful to you?