Product Review

For Accessory:

Kuryakyn 6240 ISO-Grips - 1 inch Bars (Honda and Suzuki)

Kuryakyn 6240 ISO-Grips - 1 inch Bars (Honda and Suzuki)

Reviewed by: Dave Hammer (dbhammer
Reviewed for: 1100 Shadow VT1100C
Used for: 6-12 months

Ratings:
Overall Rating: 5
Ease of install: 5
Value: 5
Would buy again: yes




Review Summary:
If you don't have these yet - Get'em. I read all the reviews and issues people had with installing them with the fast set glue. The trick is to test fit them dry, mark the proper position, and remove the ends first so that trapped air has somewhere to go. I used a small piece of masking tape on the new grip and on the switch housing and simply put a pencil mark across them for alignment. Once I was happy with the position, I removed them, cleaned everything up and applied the glue per the instructions. Make sure to give them a partial twist as they go on to distribute the glue and move fast. You'll have a few seconds to push them on and re-align your marks. Then squeeze them tight for another 30 seconds or so and you're done. While doing this install I also put on the BreakAway Production Cruise Control. The fit of the cruise control over the ISO Grips is tight but you can make it happen. I pushed it over the grip before gluing them in place.


Review Pros:



Review Cons:



Review Improvements:



Review Tools:


3 out of 3 members found this review helpful.

Was this review helpful to you?



}