Product Review

For Accessory:

Electrical Connection Turn Signal Conversion Kit

Electrical Connection Turn Signal Conversion Kit

Reviewed by: Steve (theturbo
Reviewed for: 0 1300 V-Star
Used for: < 1 month

Overall Rating: 4
Ease of install: 3
Value: 5
Would buy again: yes

Review Summary:
A great item to raise your visibility from the rear. I think the supplied t-tap connectors aren't the greatest fit to the bike wiring, and soldering is a better option. I shortened the supplied long black wiring and put the whole connected bundle under the plastic cover behind the licence plate. I did not cut into the taillight/brake light loom under the fender, instead I used the licence plate lamp wire to connect to the GREEN wire on the supplied run/brake circuit. I then ran a single wire from the the yellow wire (brake light wiring that is inside the sheathed loom under the bike seat) back to the wiring bundle I installed behind the licence plate. Note the instruction sheet at the CC website shows the slip-on LED arrangement ie the led ring shown has a heat resistant rubber grommet to allow the led ring to fit snugly over the installed indicator lamp and I believe that pictured item to be p/no EC-01314, but this kit number EC-01315 supplied here is the one that silicones the LED ring onto the inside of the indicator lens cover, which covers most motorcycle setups. See my pics and video link at:

Review Pros:

Review Cons:

Review Improvements:

Review Tools:

Was this review helpful to you?

Powered by IISpeed - Google PageSpeed optimization for Microsoft IIS and ASP.NET